Laminating Debubblers One Machine KT-101

This is touch systemlaminating and bubble remove 2 in 1 machine,Built-in air compressor and vacuumpump 。Laminatingand bubble remove only one step ,100% no bubbles.

Operating steps:

1.Plug in power line ,turn on the power switch.

2.Adjust laminating pressure to 0.5Mpa.

3.Touch system start ，click"setting".

4.Set the "vacuum time" to 15S，"laminating time" 25S，"Debubble time" 5-10M，"Laminating debubble temp"40degree，Click"comfirm".

5.Open the machine cover lid ，tear off the oca protect film.

6.Put the glass on lcd ，then use one finger click the middle screen softly.　

7.Put it to laminating area in order ，close the cover lid ,Tighten the screws.

8.Click "automatic",press the start button，vacuum air-removed start , Tighten the scews again .

9.It will turn to bubble remove mode after 25 seconds automaticly， it will automatic exhaust after debubble .

10.Loosen the screws，Take out the screen .