Pneumatic frame machine KT-302
Product Name:KT-302
This is a built-in air compressor automatic frame bracket laminating machine.iphone4,iphone5,( 6plus/6S plus）5.5 Use the same up mould.With newest 5pcs of iphone moulds(4lower moulds & 1 upper mould).
Operating steps:
1. Plug the power cord,open the power switch.
2. Rotating the stop switch clockwise,it would gently bounce.
3. Open the heating switch,Set the temperature to 180℃,Setthe time to 6 seconds.
4. Put the ready screen into the corresponding lower mould，Put the flat cable towards right,Open the side automatic switch.
5. Push into the floor, when palte touches the sensor, the upper mould will press down automatically，After 6 seconds,itwould automatically bounce, take out the screen.
* Be careful of the high temperature heated baseplate.
There are two ways to Press：
(1) Pressing the left and right start button together,it is manual press state；
(2)Open the side automatic switch is automatical press state.
* Different mode and workmanship of the frame machine have different set temperature and press time.
1. Plug the power cord,open the power switch.
2. Rotating the stop switch clockwise,it would gently bounce.
3. Open the heating switch,Set the temperature to 180℃,Setthe time to 6 seconds.
4. Put the ready screen into the corresponding lower mould，Put the flat cable towards right,Open the side automatic switch.
5. Push into the floor, when palte touches the sensor, the upper mould will press down automatically，After 6 seconds,itwould automatically bounce, take out the screen.
* Be careful of the high temperature heated baseplate.
There are two ways to Press：
(1) Pressing the left and right start button together,it is manual press state；
(2)Open the side automatic switch is automatical press state.
* Different mode and workmanship of the frame machine have different set temperature and press time.
